home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
The 640 MEG Shareware Studio 2
/
The 640 Meg Shareware Studio CD-ROM Volume II (Data Express)(1993).ISO
/
bbs
/
cr100.zip
/
CONFREST.DOC
next >
Wrap
Text File
|
1992-10-27
|
3KB
|
142 lines
CONFERENCE RESET!
(C) Copyright 1992 by Online Computer Resources
All Rights Reserved
CONFREST v1.00
CONFERENCE RESET! - Page 1
TABLE OF CONTENTS
Introduction . . . . . . . . . . . . . . . . . . . . 2
Notice . . . . . . . . . . . . . . . . . . . . . . . 2
Operation . . . . . . . . . . . . . . . . . . . . . 3
Product Support . . . . . . . . . . . . . . . . . . 4
CONFERENCE RESET! - Page 2
INTRODUCTION
CONFERENCE RESET is a program for reseting the active
conference number for a caller when they log off a
WILDCAT! v3.+ BBS. It is to be used in a POSTCALL.BAT
file. For example, if a caller is active in conference
number 20, you can use CONFERENCE RESET to reset the
callers active conference number to a number of your
choice when they log off the BBS. This program is only
valid with WILDCAT! v3.+ software.
NOTICE
CONFERENCE RESET is not supplied with any sort of guarantee.
You use CONFERENCE RESET at your own risk.
The following names are either trademarks or the work of the
individuals and/or companies shown:
WILDCAT! v3.+ - Mustang Software Inc.
CONFERENCE RESET! - Page 3
OPERATION
Put the CONFERENCE RESET .EXE file (CONFREST.EXE) in
the subdirectory that contains your MAKEWILD.DAT file.
This file must be present for CONFERENCE RESET to work.
Usually this is the \WC30 directory. The format of the
command to run CONFERENCE RESET is as follows:
CONFREST <conf #>
Where <conf #> is a valid conference number that you
have defined in your MAKEWILD settings. <conf #> must
be from 0 through 999. For example,
CONFREST 0
will reset the active conference for the last caller to
0 (zero) when the caller logs off the BBS.
NOTE: CONFERENCE RESET will *NOT* work if you use
AUTONODE to assign a node number when running
multiple nodes. CONFERENCE RESET will only work
if you use the WCNODEID environment variable to
set the node number when running WILDCAT! in a
multiple node environment. CONFERENCE RESET will
work just fine when used with the single line
copy of WILDCAT! (WCNODEID need not be set). So,
if you run more than one node, make sure that you
use the WCNODEID environment variable to ensure
that CONFERENCE RESET will work properly.
CONFERENCE RESET! - Page 4
PRODUCT SUPPORT
Since CONFERENCE RESET is "freely available," direct product
support, per se, is not available. If you have problems or
questions with CONFERENCE RESET, you are welcome to send an
inquiry to:
1:161/503 or call our BBS at (510) 687-0236
Thanks for using CONFERENCE RESET!